Extreem high / low of the Spread in Builder Support for analyze module

2 posts   •   Page 1 of 1
moti
 
Posts: 9
Joined: Thu Sep 12, 2013 2:31 pm

Extreem high / low of the Spread in Builder

by moti » Wed Nov 20, 2013 5:40 pm

Hello,

Something that i notice when I open Any spread ,
Always Always the Highest High of the Current spread has been the SAME ( not higher , not lower... ) As the Highest high of 5 & 10 ,15 years , Same for the Lowest low of the current spread
Please advise what is this phenomenon ?

Thank you,
Moti

Roman
 
Posts: 145
Joined: Tue May 14, 2013 12:59 pm

Re: Extreem high / low of the Spread in Builder

by Roman » Wed Nov 20, 2013 6:05 pm

Hi Moti

I'm not sure if I understand your question, but I think that you are asking about spread and seasonal pattern alignment (if I'm not right, please specify better your question and ideally attach screenshot).

There is a lot of misunderstanding in how spread and pattern alignment works and is commonly is used in wrong way. I wrote an article about it, where it's explained. Please read it:

http://www.seasonalgo.com/patterns

From the article, you will understand why patterns lows or highs matches.

Let me know if anything is not clear

Roman

2 posts   •   Page 1 of 1
It is currently Sat Dec 07, 2024 12:47 pm